- per page
Titan Co2 Regulator and Solonoid
•Compatible with Titan Controls CO2 Controller or other 120 volt controllers and timers.
•Precision Accuracy Flow Meter - .5 to 15 SCF/hour.
•CO2 helps increase overall plant growth.
•Features heavy-duty solenoid valve.
•Brass construction for long-lasting dependability and durability.
•Includes 12' of CO2 dispensing line.
•Powered by 6' - 120 volt grounded power cord.
•Two plastic tank washers included.
•High quality oil-less pressure gauge.
•3 Year Warranty
Prewired for cooling
? Single stage thermostat for cooling
? NEMA 4 enclosure
? Larger, easy read, 40 - 100? F dial
? Multi position mounting
? Higher amperage rating
? Stainless steel coil
- 15 amp- 120v
- 12amp - 240v
- 10amp - 277v
ExHale or EZ CO2
Depending on supply the brand may vary.
ExHale cultivates CO2 24 hours a day with no need to refill bottles or use expensive CO2 production units. The power of ExHale lies in the mycelial mass inside the vented cultivator. This mycelial mass cultivates CO2 and the one-way breather patch releases CO2 continually for up to 6 months.
Grozone CY1 Day & Night Periodic Timer with photocell
DESCRIPTION
- Controls any 120Vac equipment such as pumps or fans on a periodic repeat cycle.
- The ON duration spans from 10 sec to 20 minutes.
- The OFF duration spans from 1 minutes to 12 hours.
- The unit can function day and night or during day time only.
INCLUDED MODULES AND ACCESSORIES
- One plug-in type module.
- One user guide.
- One screw kit
DESCRIPTION
Day and Night temperature settings: 48?F to 104?F (9?C to 40?C).
Day and Night humidity settings: 10% to 100%
User can select one among five operating modes: Cooling, Cooling & Dehumidifying, Dehumidifying, Humidifying, Heating.
User-Set Low-Temperature Limit (for Cooling & Dehum. mode only)..
Remote Sensor w/ 25-ft cable (included).
Bargraph display.
15 Amps Output.
INCLUDED MODULES AND ACCESSORIES
One plug-in type module.
One Sensor.
One 25-ft cable.
One user guide.
One screw kit .
Grozone SCO2 The Simple One CO2 Controller
DESCRIPTION
This easy to use CO2 controller determines precisely when to activate and shut-off CO2 generators to maintain user-defined LOW and HIGH CO2 values in the grow room. The unit can deactivate CO2 enrichment during the night cycle and perform CO2 evacuation as well. The CO2 sensor is located in the controller box.
INCLUDED MODULES AND ACCESSORIES
- One main controller box.
- Three lint filters to protect Co2 Sensor.
- One user guide.
- One screw kit.
Grozone TP1 Day/Night Thermostat
DESCRIPTION
Controls cooling or heating equipment according to a daytime or nighttime set-point.
6 foot cord with temperature sensor precise to 2°F / 1°C.
Can power 120Vac equipment up to 15 amp.
Typical control differential stands between 4° and 7°F / 2° and 4°C.
INCLUDED MODULES AND ACCESSORIES
One plug-in type module.
One user guide.
One screw kit
Grozone TP2 Adjustable differential Thermostat
DESCRIPTION
- Controls cooling or heating equipment according to a setpoint and an adjustable differential from 4° to 20°F / 2° to 11°C.
- 6 foot cord with temperature sensor precise to 2°F / 1°C.
- Can power 120Vac equipment up to 15 amp.
INCLUDED MODULES AND ACCESSORIES
- One plug-in type module.
- One user guide.
- One screw kit
Grozone TP3 High temperature shut-off Thermostat
DESCRIPTION
- Automatically shuts down lighting and/or other equipment when a high temperature setpoint is reached.
- Once turned-off, the unit will run a user selected delay from 0 to 30 minutes before turning back on or will hold restart until manual reset (temperature setback of 5° or 10° F / 3° to 5°C).
- 6 foot cord with temperature sensor precise to 2°F / 1°C.
- Can power 120Vac equipment up to 15 amp.
- To be used in conjunction with 120Vac triggered high-load or light switcher like the LS1, LS2 or LS3.
INCLUDED MODULES AND ACCESSORIES
- One plug-in type module.
- One user guide.
- One screw kit
- per page